Guy that came out was a cool guy he just came from Russia to escape the craziness. I had to recommend him. He’s a good guy very professional worked hard pretty fun talking to…
Range Oven Not Heating in Austin, TX
On combo ranges, oven no-heat complaints still follow bake/broil/igniter/sensor diagnostics, but we also check whether shared control faults affect both cooktop and oven functions.
Call us — $79 diagnostic- Serving Austin ZIPs: 78701, 78702, 78703, 78704, 78705, 78745, 78758, 78759, 78729, 78748
- $39 diagnostic applies toward repair
- Book online 24/7
- Same day service when available
- Typical labor: $129-$219 (labor only, parts extra)
- Up to 90 day warranty
One local technician assigned per job. No marketplaces or call centers.
Range Oven Not Heating — Combo Unit Diagnostics
This page covers the oven section inside a range. Standalone wall and built-in oven diagnostics are covered on our dedicated oven pages.
Typical symptoms
- Surface burners work but oven cavity stays cold
- Preheat starts then stalls below setpoint
- Broil works but bake does not, or vice versa
- Gas igniter glows without burner ignition
Common causes
- Failed bake or broil heating component
- Weak gas igniter under load
- Sensor drift or harness failure
- Control relay output fault
- Thermal safety cutoff open
Need service for a standalone wall or built-in oven instead of a combo range? See our oven repair pages for that platform-specific workflow.
How We Diagnose a Range Oven That Won't Heat
We verify cavity heating circuits and control outputs while checking for shared control failures across the combo unit.
Bake and broil circuit verification
We test both heat paths to identify single-circuit versus full no-heat failures.
Gas igniter or electric element performance
Heat-source output is measured under load to avoid replacing controls unnecessarily.
Sensor and safety chain checks
Temperature sensors and thermal safeties are validated before board replacement.
Shared control diagnostics
Combo units may show linked faults across oven and surface functions when control sections fail.
Combo Range Oven Repair Expectations
Element, igniter, and sensor repairs are commonly worthwhile on mid-life ranges. Shared control board work can cost more, so we confirm outputs first (typical labor $129-$219, parts extra).
Range Oven Not Heating FAQ
Austin combo-range questions.
Why do burners still work if the oven does not?
Ranges often have separate surface and cavity heat paths; one can fail while the other still works.
Is this the same as standalone oven repair?
Core heating checks are similar, but combo ranges also require shared-control evaluation.
Should I use broil if bake is out?
Temporary use may be possible, but we recommend diagnosis to avoid secondary control damage.