Pauline P
My washing machine GE stopped filling with water and was just tumbling half-dry clothes around the bottom of the drum. I contacted one repair company, and they replaced two parts…
Local Austin Oven Repair · Not Heating · Book Online 24/7 · 90 Day Warranty
Oven Not Heating in Austin, TX
If the oven stays cold or preheat stalls, we verify whether heat is missing from bake, broil, or both. That split quickly narrows element, igniter, sensor, or control relay faults.
Call us — $79 diagnostic- Serving Austin ZIPs: 78701, 78702, 78703, 78704, 78705, 78745, 78758, 78759, 78729, 78748
- $39 diagnostic applies toward repair
- Book online 24/7
- Same day service when available
- Typical labor: $129-$219 (labor only, parts extra)
- Up to 90 day warranty
One local technician assigned per job. No marketplaces or call centers.
Oven Not Heating — Bake, Broil, and Preheat Path
No-heat failures are not one generic problem. Electric ovens fail differently from gas ovens, and a bake-only failure points somewhere else than no-heat on both bake and broil.
Typical symptoms
- Oven powers on but cavity stays cold
- Preheat starts then stalls far below set temperature
- Broil works but bake does not, or bake works but broil does not
- Gas oven igniter glows but burner never lights
- Error code or shutdown after attempted preheat
Common causes we verify
- Open bake or broil element on electric models
- Weak hot-surface igniter on gas models (glow without valve opening)
- Sensor out of range causing bad temperature feedback
- Thermal fuse or high-limit safety device open
- Relay board or main control not sending heat output
Need help with surface burners or cooktop ignition instead of cavity heat? See our range and stove repair pages; this page is for oven-cavity heating failures.
How We Diagnose an Oven That Is Not Heating
We confirm supply, then test heating outputs under load, sensor feedback, and control relays before recommending parts.
Bake and broil output test
We check whether each circuit energizes and whether one side fails while the other works.
Gas igniter amperage
For gas ovens, we measure igniter draw; weak igniters often glow but never open the gas valve.
Sensor and thermal safety path
Out-of-range sensors or open fuses can block heat even when the control appears normal.
Control relay verification
We verify relay output to avoid replacing a board when a sensor or harness is the real cause.
Repair vs Replace for No-Heat Ovens
Element, igniter, and sensor repairs are common and usually practical on mid-life units. Relay board repairs cost more, so we quote after test confirmation (typical labor $129-$219, parts extra).
Oven Not Heating FAQ
What Austin customers ask before booking.
Why does my igniter glow but the oven does not light?
Glow does not guarantee enough current. A weak igniter often cannot open the gas valve under load.
Can one bad element make preheat very slow?
Yes. If bake or broil is out, preheat may crawl or never reach setpoint.
Is this page for burner problems too?
No. Burner and cooktop issues are covered on range and stove repair pages.
Does the $39 diagnostic apply toward repair?
Yes, it applies toward the repair total if you proceed.