My washing machine GE stopped filling with water and was just tumbling half-dry clothes around the bottom of the drum. I contacted one repair company, and they replaced two parts…
Gas Oven Not Igniting in Austin, TX
Most gas ovens that fail to ignite have a weak hot-surface igniter, not a bad gas valve. We confirm current draw and valve response before replacing parts.
Call us — $79 diagnostic- Serving Austin ZIPs: 78701, 78702, 78703, 78704, 78705, 78745, 78758, 78759, 78729, 78748
- $39 diagnostic applies toward repair
- Book online 24/7
- Same day service when available
- Typical labor: $129-$219 (labor only, parts extra)
- Up to 90 day warranty
One local technician assigned per job. No marketplaces or call centers.
Gas Oven Not Igniting — Why the Burner Does Not Light
Ignition failures usually happen at the igniter-current stage. The igniter can look normal but still fail to pull enough amperage to open the valve safely.
Typical symptoms
- Clicking or glow without burner ignition
- Long delay before ignition, then no sustained flame
- Intermittent ignition that worsens over time
- Strong broil performance but weak or failed bake ignition
Common causes
- Weak bake igniter with low current draw
- Open igniter circuit or damaged harness
- Gas valve not opening under load
- Control board not sending ignition command
- Safety lockout from prior failed ignition attempts
How We Diagnose a Gas Oven That Won't Ignite
We test ignition current, valve behavior, and command output in sequence for a safe diagnosis.
Igniter amperage measurement
Current draw confirms whether the igniter can actually open the gas valve.
Gas valve response
We verify valve operation only after confirming proper igniter and control input.
Control and safety path
We check whether the board is calling for ignition and whether lockouts are active.
Harness and connection integrity
Heat-damaged connectors or loose terminals often cause intermittent ignition.
Gas Ignition Repair Expectations
Igniter replacement is one of the most common gas oven repairs and often straightforward. Valve and control repairs are quoted only after verified electrical and gas-path testing (labor typically $129-$219).
Gas Oven Not Igniting FAQ
Quick answers for Austin gas-oven calls.
Is it safe to keep trying start when it won't ignite?
Repeated retries are not recommended. Stop and book service if ignition keeps failing.
Can the igniter be bad even if it glows?
Yes. Many weak igniters glow but cannot reach the current needed to open the valve.
Do you service both bake and broil ignition systems?
Yes. We test each circuit because one side can fail while the other still works.