Round Rock, TX · Dishwasher Repair · $39 Diagnostic

Your Dishwasher Not Draining in Round Rock

Dishwasher acting up in Round Rock? We verify the failure before quoting parts.

  • Typical repair time: 1-2 hours
  • Typical labor: $140-$230 (labor only, parts extra)
  • Coverage: 78664, 78665, 78681

What it usually means when your dishwasher is not draining

Standing water after a cycle usually means a clogged filter or sump, a blocked drain hose or disposal port, or a drain pump that cannot move water — we test the path before quoting a pump.

What a technician checks on site

  • Clean and inspect fine filter, coarse filter, and sump area
  • Check drain hose, high loop, air gap, and disposal connection
  • Test drain pump motor and impeller under load
  • Verify control sends drain voltage and float/leak inputs are normal

Other dishwasher problems we fix in Round Rock

If this symptom doesn’t match exactly, check these common issues we see in Round Rock, TX.

Not Cleaning Dishes

Dirty dishes or plastic that stays wet often mean weak spray pressure, a failing circulation pump, low wash temperature, or a stuck diverter — not just detergent choice.

Learn more →

Leaking Water

Leaks are traced by location: door front (gasket or latch), under the sink (inlet or drain hose), or toe-kick area (pump seal, sump, or base pan on leak-protected models).

Learn more →

Won’t Start

No lights or no cycle start usually trace to tripped power, a door latch that does not prove closed, or control/touch panel power — not a failed wash pump.

Learn more →

Making Loud Noise

Grinding during wash often means debris in the sump; buzzing during drain points to a struggling drain pump — we match the sound to fill, wash, or drain phase.

Learn more →

Not sure if this is your issue?

You can also start from the main Dishwasher Repair in Round Rock page and describe what you’re seeing — our technician will classify the failure during the diagnostic.

Go to Dishwasher Repair in Round Rock