Fast diagnosis in Leander, TX. If it’s cooling-related, we’ll advise how to protect food until service.
Real recent repair cases. Prices shown are from past completed jobs.
Top verified matches for Whirlpool Refrigerator Repair issue “Door Not Sealing” in Leander.
The customer reported water leaking from the refrigerator door when using the water dispenser.
The technician replaced the damaged water tank in the refrigerator door. After the repair was completed, the water dispenser system was fully tested. The dispenser operated normally, and no leaks were observed.
Parts:
* Prices shown are from past completed jobs and include parts and labor. Actual repair cost varies by model, diagnosis, and part availability.
This refrigerator symptom typically indicates a cooling, airflow, defrost, or sensing system failure.
When a refrigerator stops cooling, the cause is usually airflow, compressor start components, or a sealed system issue.
Learn more →If temperatures are higher than normal but the unit still runs, the issue is often restricted airflow, dirty condenser coils, or weak cooling performance.
Learn more →When the freezer section warms up, it’s often a defrost issue, fan failure, or airflow blockage from frost buildup.
Learn more →Excess frost usually points to a defrost system failure, door seal leak, or airflow/damper problems.
Learn more →If the evaporator ices over, cold air can’t circulate. This is usually a defrost heater/thermostat/control issue.
Learn more →Most refrigerator leaks are caused by a clogged defrost drain, drain line issues, or a faulty water inlet system.
Learn more →Unusual refrigerator noises usually come from fan motors, ice/frost contacting a fan blade, or compressor vibration.
Learn more →Constant running typically means the unit can’t reach set temperature due to airflow blockage, dirty condenser, weak compressor, or sensor issues.
Learn more →Meaning: Power Outage / Power Loss
Typical fix: Clear code; verify outlet/power. If frequent, inspect wiring and control.
Meaning: Defrost Heater Error
Typical fix: Test defrost heater circuit and defrost sensor; verify board output.
Meaning: Communication Fault (UI ↔ Control)
Typical fix: Check harness connections; if persists, diagnose UI/control board.
Most jobs fall into the $120-$290 labor range. The technician confirms the exact failure during the $39 diagnostic.
Some symptoms are safety-related. If you’re unsure, stop using the unit until a technician confirms the cause.
Yes — coverage includes 78641, 78646 and nearby areas.
