Local GE refrigerator repair in Leander. We check the likely causes first to avoid wasted time and money.
Real recent repair cases. Prices shown are from past completed jobs.
Top verified matches for GE Refrigerator Repair issue “Not Cooling” in Leander.
The customer reported water leaking from the refrigerator door when using the water dispenser.
The technician replaced the damaged water tank in the refrigerator door. After the repair was completed, the water dispenser system was fully tested. The dispenser operated normally, and no leaks were observed.
Parts:
* Prices shown are from past completed jobs and include parts and labor. Actual repair cost varies by model, diagnosis, and part availability.
When a refrigerator stops cooling, the cause is usually airflow, compressor start components, or a sealed system issue.
If temperatures are higher than normal but the unit still runs, the issue is often restricted airflow, dirty condenser coils, or weak cooling performance.
Learn more →When the freezer section warms up, it’s often a defrost issue, fan failure, or airflow blockage from frost buildup.
Learn more →Excess frost usually points to a defrost system failure, door seal leak, or airflow/damper problems.
Learn more →If the evaporator ices over, cold air can’t circulate. This is usually a defrost heater/thermostat/control issue.
Learn more →Most refrigerator leaks are caused by a clogged defrost drain, drain line issues, or a faulty water inlet system.
Learn more →Unusual refrigerator noises usually come from fan motors, ice/frost contacting a fan blade, or compressor vibration.
Learn more →A poor door seal causes temperature swings, frost buildup, and longer compressor run times.
Learn more →Constant running typically means the unit can’t reach set temperature due to airflow blockage, dirty condenser, weak compressor, or sensor issues.
Learn more →Meaning: Temperature / Sensor Related Fault (platform dependent)
Typical fix: Check thermistors, harness connections, and cooling performance.
Meaning: Fresh Food Temp Sensor / Cooling Fault (platform dependent)
Typical fix: Test fresh food thermistor; verify fans and damper operation.
Meaning: Power Failure
Typical fix: Clear code; verify stable power. If recurring, inspect wiring and control.
Most jobs fall into the $120-$290 labor range. The technician confirms the exact failure during the $39 diagnostic.
Some symptoms are safety-related. If you’re unsure, stop using the unit until a technician confirms the cause.
Yes — coverage includes 78641, 78646 and nearby areas.
