Not Igniting (Gas)
Most gas ovens that fail to ignite have an igniter that glows but cannot pull enough amperage to open the gas valve under load.
Learn more →Leander, TX · Oven Repair · $39 Diagnostic
Your Oven Not Heating in Leander
Serving 78641, 78646. We diagnose ovens weekly in Leander.
- Typical repair time: 1-2 hours
- Typical labor: $129-$219 (labor only, parts extra)
- Coverage: 78641, 78646
What it usually means when your oven is not heating
If the oven stays cold or preheat stalls, we first confirm whether bake, broil, or both are missing heat. That split points to elements/igniters, sensing faults, thermal limits, or relay output problems.
What a technician checks on site
- Test bake and broil elements (electric) or igniter amperage (gas)
- Verify temperature sensor resistance and harness
- Check thermal fuse / high-limit safety devices (if present)
- Confirm control board or relay output and wiring integrity
Other oven problems we fix in Leander
If this symptom doesn’t match exactly, check these common issues we see in Leander, TX.
Not Reaching Temperature
Slow preheat or low bake temperature usually comes from weak heat output, sensor drift, or control calibration faults rather than one generic bad part.
Learn more →Uneven Baking
Uneven baking and hot spots usually point to convection airflow problems, weak heating zones, or temperature sensing drift.
Learn more →Door Not Closing / Seal Issues
If the oven door will not close or the gasket leaks, heat escapes, preheat slows, and electronics can run hotter than normal.
Learn more →Not sure if this is your issue?
You can also start from the main Oven Repair in Leander page and describe what you’re seeing — our technician will classify the failure during the diagnostic.
Go to Oven Repair in Leander →