Georgetown, TX · Danby Ice Maker · $39 Diagnostic

Danby Ice Maker Producing Ice Slowly in Georgetown

If your Danby ice maker has this symptom, we’ll confirm the failure fast in Georgetown.

What it usually means when your Danby ice maker is slow ice production

We confirm the exact failure on-site before recommending any repair.

When an ice maker stops producing ice, the issue is usually water supply, a failed ice maker module, or a control/sensor problem.

If ice is made but not dispensed, the issue is usually mechanical — auger motor, dispenser door, or switch failure.

Small or hollow ice cubes almost always indicate low water flow into the ice maker mold.

Ice maker leaks are usually caused by overfilling, cracked molds, or water valve issues.

Bad tasting ice is usually caused by an old filter, stagnant water, or contamination inside the ice maker system.

We service many Danby models — model number optional when booking.

We diagnose Danby codes — even rare or undocumented ones.

Most jobs fall into the $150-$220 labor range. The technician confirms the exact failure during the $39 diagnostic.

Some symptoms are safety-related. If you’re unsure, stop using the unit until a technician confirms the cause.

Yes — coverage includes 78626, 78628, 78633 and nearby areas.