Fast, local Roper repair in Bee Cave, TX. Clear diagnostic first, repair only after approval.
Real recent repair cases. Prices shown are from past completed jobs.
Top verified matches for Roper Washer in Bee Cave.
The LG washer is not draining and is showing an OE error code.
The drain pump was found to be non-operational despite receiving 120 volts of supply and having a resistance of 15 Ohm.
The drain pump was replaced to resolve the drainage issue. After the repair, the unit was tested and no additional issues were discovered.
Local proof: West Austin · 78746 · Near Barton Creek
Completion status: REPAIRED
The washer was making loud noise and shaking heavily during operation.
All four shock absorbers were found to be damaged, with the tub and drum hanging on one spring. Initial tests showed no power reaching the drain pump, but subsequent tests indicated the drain pump op…
The technician replaced all four shock absorbers. After reassembly, the unit was tested and confirmed to be functioning correctly.
Local proof: Southwest Austin · 78735 · Near West Oak Hill
Completion status: REPAIRED
Washer was not agitating, washing, or spinning.
The washer was not transferring power from the motor to the gearcase, preventing agitation, washing, and spinning. A worn motor coupling was identified, along with a lid lock that was not engaging co…
The motor coupling and lid lock were replaced. The mounting of the washer body components was restored to their original condition.
Local proof: Austin · 78758 · Near Quail Creek
Completion status: REPAIRED
Washer does not enter the spin cycle.
The shifter was found to transition into spin mode successfully, but the basket failed to spin. Testing indicated the shifter is functioning correctly, but the run capacitor was below specification.
The capacitor was replaced as it was found to have a measured capacitance of approximately 29 µF, which is below the required 45 µF.
Local proof: Austin · 78746 · Near Zilker Park
Completion status: REPAIRED
* Prices shown are from past completed jobs and include parts and labor. Actual repair cost varies by model, diagnosis, and part availability.
In Bee Cave, many Roper washer issues are related to draining, spinning, and sensing. We verify the root cause first.
A code is a clue, not a diagnosis. We verify the condition on-site in Bee Cave.
If the cycle ends with standing water, the washer is usually blocked, the pump is failing, or the drain path has an obstruction.
Quick tip: Check the drain hose behind the washer for kinks. If your model has a drain filter/coin trap, clean it (have towels ready).
Learn more →No-spin is often related to the lid/door lock system, a worn drive component, or an out-of-balance protection trigger.
Quick tip: Redistribute the load and try a spin-only cycle. If the washer is severely off-balance, it may refuse to spin for safety.
Learn more →Leaks can come from hoses, the pump, the tub seal, or the door boot (front-load). The source matters — we confirm it during the diagnostic.
Quick tip: Turn off both water supply valves and check the inlet hoses for dripping at the wall and at the washer connection.
Learn more →Noise can be caused by worn bearings, loose objects, failing suspension/shocks, or a drive component under load.
Quick tip: Run a short spin cycle empty. If it’s still loud, it’s likely mechanical (bearings/suspension) rather than the load.
Learn more →A washer that won’t start is often caused by a door/lid lock issue, power problem, or a control failure — not always a bad motor.
Quick tip: Make sure the door/lid is fully closed and latched. If it’s a GFCI outlet, reset it and try again.
Learn more →We service many Roper models — model number optional when booking.
Most jobs fall into the $110-$219 labor range. Parts priced separately after diagnostic.
When available, yes. We also provide aftermarket options if cheaper.
The technician compares repair cost with age/condition and gives a clear recommendation.
