Trusted Frigidaire fridge repair across 78701, 78702, 78703, 78704, 78705, 78745, 78758, 78759, 78729, 78748. No spam calls, no bidding.
Local coverage across 78701, 78702, 78703, 78704, 78705, 78745, 78758, 78759, 78729, 78748. One verified tech, no bidding marketplace — just diagnose → quote → you decide.
Codes aren’t random — they’re conditions the refrigerator detects. We’ll confirm what triggered it and fix the cause.
When a refrigerator stops cooling, the cause is usually airflow, compressor start components, or a sealed system issue.
Quick tip: Clean the condenser coils and make sure food items are not blocking air vents inside the fridge.
Learn more →If temperatures are higher than normal but the unit still runs, the issue is often restricted airflow, dirty condenser coils, or weak cooling performance.
Quick tip: Set the fridge to the recommended temperature and wait 12–24 hours. If temps don’t stabilize, book a diagnostic.
Learn more →When the freezer section warms up, it’s often a defrost issue, fan failure, or airflow blockage from frost buildup.
Quick tip: If there’s heavy frost on the back wall, limit door openings and book service—airflow is likely blocked.
Learn more →Excess frost usually points to a defrost system failure, door seal leak, or airflow/damper problems.
Quick tip: Check the door gasket for gaps and make sure nothing prevents the door from closing fully.
Learn more →If the evaporator ices over, cold air can’t circulate. This is usually a defrost heater/thermostat/control issue.
Quick tip: If airflow is weak and frost is heavy, don’t keep running it for days — it can stress the compressor.
Learn more →Most refrigerator leaks are caused by a clogged defrost drain, drain line issues, or a faulty water inlet system.
Quick tip: Look for ice buildup near the drain area and clear visible debris. If leaking is active, shut off the water supply.
Learn more →Unusual refrigerator noises usually come from fan motors, ice/frost contacting a fan blade, or compressor vibration.
Quick tip: Make sure the refrigerator is level and not touching cabinets or walls—vibration can amplify noise.
Learn more →A poor door seal causes temperature swings, frost buildup, and longer compressor run times.
Quick tip: Try the paper test: close the door on a sheet of paper. If it slides out easily, the seal may be weak.
Learn more →Constant running typically means the unit can’t reach set temperature due to airflow blockage, dirty condenser, weak compressor, or sensor issues.
Quick tip: Vacuum the condenser area and ensure ventilation clearance. If temps don’t improve, book a diagnostic.
Learn more →Most jobs fall into the $120-$290 labor range. Parts priced separately after diagnostic.
When available, yes. We also provide aftermarket options if cheaper.
The technician compares repair cost with age/condition and gives a clear recommendation.
