Austin, TX · GE Profile Ice Maker · $39 Diagnostic

GE Profile Ice Maker Leaking Water in Austin

If your GE Profile ice maker has this symptom, we’ll confirm the failure fast in Austin.

Typical repair time: 1 hour
Typical labor: $150-$220 (labor only)
Coverage: 78701, 78702, 78703, 78704, 78705, 78745, 78758, 78759, 78729, 78748

What it usually means when your GE Profile ice maker is leaking water

We confirm the exact failure on-site before recommending any repair.

When an ice maker stops producing ice, the issue is usually water supply, a failed ice maker module, or a control/sensor problem.

If ice is made but not dispensed, the issue is usually mechanical — auger motor, dispenser door, or switch failure.

Slow ice production usually means temperature issues, low water pressure, or a failing ice maker module.

Small or hollow ice cubes almost always indicate low water flow into the ice maker mold.

Bad tasting ice is usually caused by an old filter, stagnant water, or contamination inside the ice maker system.

We service many GE Profile models — model number optional when booking.

We diagnose GE Profile codes — even rare or undocumented ones.

Most jobs fall into the $150-$220 labor range. The technician confirms the exact failure during the $39 diagnostic.

Some symptoms are safety-related. If you’re unsure, stop using the unit until a technician confirms the cause.

Yes — coverage includes 78701, 78702, 78703, 78704, 78705, 78745, 78758, 78759, 78729, 78748 and nearby areas.